CRH0805F68R0P05Z (0805 68R 0.25W) Ever Ohms Chip Resistor: Parameters and Applications
CRH0805F68R0P05Z is a high power thick film chip resistor from the CRH series of Ever Ohms (UniOhm / 天二科技). It comes in an 0805 package with a 68Ω resistance, ±1% tolerance, 0.25W rated power and a ±100ppm/℃ temperature coefficient. Compared with a standard CR0805 part rated at 0.125W, the CRH version doubles the power density in the same footprint, which is why it shows up so often in power supplies, gate drive stages and industrial control boards.
Reading the part number
表格
Key electrical and mechanical data
- Rated power: 0.25W at 70℃ ambient; derate above that temperature per the curve
- Resistance and tolerance: 68Ω, ±1% (67.32Ω to 68.68Ω)
- TCR: ±100ppm/℃
- Operating temperature: -55℃ to +155℃
- Maximum working voltage 150V; short term overload voltage 300V
- Construction: alumina substrate with ruthenium based thick film element; three layer termination with nickel barrier for good solderability
- Process compatible with reflow and wave soldering, suitable for high speed pick and place
What 0.25W on 68Ω actually means
Using P = I²R, full rated power corresponds to roughly 60mA continuous current or 4.1V continuous voltage. That figure shows the headroom of this 0805 68R 0.25W Ever Ohms resistor is intended for power on surges, inrush and short pulses rather than continuous operation at the limit. Two constraints matter in design:
Derating. The rating is defined at 70℃ ambient. For enclosed enclosures or hot industrial cabinets, keep at least 20% margin and plan around 0.2W.
Thermal path. Whether the part can really dissipate its rating depends heavily on copper area under the pads. Keep adequate copper on both terminations and add thermal vias to an inner layer or backside ground plane where needed. The same component can run more than ten degrees cooler with proper copper than without it.
Reliability and environmental behaviour
A common failure mode for chip resistors in sulphur bearing atmospheres is sulphidation open circuit: sulphur compounds penetrate the protective coating and react with the silver internal electrode to form silver sulphide, driving the resistance upward until it opens. The CRH series addresses this with a dense protective glaze plus thicker end electrodes and a nickel barrier. It is therefore suitable for outdoor telecom equipment, mining and chemical sites, coastal high humidity and salt spray environments, and non safety critical automotive circuits (automotive coverage to be confirmed against the datasheet and AEC-Q200 report).
With ±100ppm/℃ over -55℃ to +155℃, the drift from a 25℃ reference is about ±1.3% at the hot end and ±0.8% at the cold end, acceptable for most divider and sampling circuits. Higher precision requirements should move to the thin film precision range.
Typical uses of 68Ω
- Series gate resistors for MOSFET and IGBT switching, damping oscillation and controlling switching speed
- Series damping and termination on signal lines to reduce edge reflections
- Current limiting in LED drivers and backlight circuits
- Low value branches in feedback and divider networks
- Small current sensing loops
Substitution checklist
When replacing this part, verify four items: package and pad layout compatibility, rated power equal to or above the original design, tolerance and TCR meeting the accuracy budget, and whether the same sulphur resistance or automotive grade is required. Resistance accuracy between brands is usually similar; the real differences appear in long term stability, lot to lot consistency and failure modes, so run a small batch build with high temperature ageing before mass production.
Sourcing and technical support
For volume purchases, an authorised channel gives traceable lots and stable long term supply. Shenzhen Shunhai Technology Co., Ltd. (深圳市顺海科技有限公司) is an authorised distributor for Ever Ohms, covering thick film, thin film and alloy current sensing resistors, and provides genuine original parts, lot and lead time confirmation, tiered pricing, plus component selection and failure analysis support — a good fit for production programmes and long term supply agreements.
For prototyping and small replenishment orders, Huanian Mall (华年商城) allows online stock lookup and ordering with flexible minimum quantities, which suits the sample stage. Using both channels together balances fast sampling with dependable volume supply.
-
Recommended similar products:
Part Number Parameter CRH0603F910KP05Z 0603 910K 0.125W 1% CRH0603F910RP05Z 0603 910R 0.125W 1% CRH0805F9R10P05Z 0805 9.1R 0.25W 1% CRH0805F200RP05Z 0805 200R 0.25W 1% CRH0805F220KP05Z 0805 220K 0.25W 1% CRH0805F220RP05Z 0805 220R 0.25W 1% CRH0805F3K30P05Z 0805 3.3K 0.25W 1% CRH0805F68R0P05Z 0805 68R 0.25W 1% CRH0805F6R80P05Z 0805 6.8R 0.25W 1% CRH0603F910KP05Z 0603 910K 0.125W 1% CRH0603F910RP05Z 0603 910R 0.125W 1%
